Nanolex Si3D SET-ceramic coating 30ml set

Нанолекс Si3D-это керамическое покрытие, которое чрезвычайно устойчиво к воде, грязи и сильным химическим веществам, благодаря чему оно обеспечивает отличную защиту против грязи.

спасибо Si3D, очистка поверхности становится намного легче и быстрее.

Si3D creates a protective coating with a hardness of 9H, thanks to which the paint is much less prone to scratching.

чтобы дать лучшие результаты, рекомендуется сложить в 2-3 слоя.

coating perfectly protects The paintwork and rims, but also works great on headlights and plastics.

With proper care, durability of the coating is up to 3 years

Efficiency when The paint is secured with 2 layers together with rims:

30 мл - Opel Insignia

50 мл - Mercedes GL

Application method:

- Before application, the car must be cleaned of dirt, tar, металлические примеси, клей и т. д.

- On such a prepared surface, you should perform a full correction of the paint, and a минимум of "One Step"

- the car should be thoroughly cleaned of polishing paste etc. using specialized preparations of the IPA type

- Each element must be degreased 3 times 4, the last обсаливая must be best done with Nanolex EX (spray the element, wait approx. Wipe dry 1-2 minutes)

- We select an area of approx. 40x40cm or a small элемент, distribute The coating accurately with cross movements (up and down)

- Depending on the ambient temperature, we wait 30-180 seconds (at a temperature of 20 degrees Celsius 120 seconds)

- Rub thoroughly with circular movements (we don't reach! ) coating until a uniform appearance is obtained (you can help yourself with an inspection lamp, there should be a minimal голограммы, which will disappear in a dozen or so hours)

- The next layer of coating is applied after 5-15 minutes from the application of the previous layer, in the meantime, to NOT heat up the first layer, degrease etc. (at 20 degrees Celsius, we recommend 10 minutes)

- после завершения процесса применения, мы рекомендуем выйти в дневное время, чтобы убедиться, что покрытие было идеально потерто .

- Initial hardening of the coating takes place after 12 hours at a temperature of 20 degrees Celsius (the car may then come into contact with water), full hardening takes place within 1-2 weeks (after this period, the car can be мытый for the first time).

Советы:

- We recommend changing the microfiber frequently (for a car the size of an Opel Insignia we should use at least 2 microfiber)

- in case of imperfections after the coating has run in, they can be removed after 12 hours (not possible earlier! ) from the application of microfiber and a minimount of finish paste. После того, как покрытие полностью вылечено, оно может быть только удалено с полированной тканью. * Please note that after such a treatment, durability of the coating may significantly decrease!

- The coating can be heated at 60 degrees Celsius for 15 minutes

- Layering makes sense up to 3 layers inclusive

the composition of the set:

Nanolex Si3D 30 мл

Nanolex EX 200ml

Nanolex Pulley for applicator

nanolex Si3D applicator x3

Nanolex Microfiber 40х40 x2

Gloves x2