Нанолекс Si3D-это керамическое покрытие, которое чрезвычайно устойчиво к воде, грязи и сильным химическим веществам, благодаря чему оно обеспечивает отличную защиту против грязи.п>
спасибо Si3D, очистка поверхности становится намного легче и быстрее.п>
Si3D creates a protective coating with a hardness of 9H, thanks to which the paint is much less prone to scratching.п>
чтобы дать лучшие результаты, рекомендуется сложить в 2-3 слоя.п>
coating perfectly protects The paintwork and rims, but also works great on headlights and plastics.п>
With proper care, durability of the coating is up to 3 years
Efficiency when The paint is secured with 2 layers together with rims:
30 мл - Opel Insignia
50 мл - Mercedes GL
Application method:
- Before application, the car must be cleaned of dirt, tar, металлические примеси, клей и т. д.п>
- On such a prepared surface, you should perform a full correction of the paint, and a минимум of "One Step"
- the car should be thoroughly cleaned of polishing paste etc. using specialized preparations of the IPA type
- Each element must be degreased 3 times 4, the last обсаливая must be best done with Nanolex EX (spray the element, wait approx. Wipe dry 1-2 minutes)
- We select an area of approx. 40x40cm or a small элемент, distribute The coating accurately with cross movements (up and down)
- Depending on the ambient temperature, we wait 30-180 seconds (at a temperature of 20 degrees Celsius 120 seconds)
- Rub thoroughly with circular movements (we don't reach! ) coating until a uniform appearance is obtained (you can help yourself with an inspection lamp, there should be a minimal голограммы, which will disappear in a dozen or so hours)
- The next layer of coating is applied after 5-15 minutes from the application of the previous layer, in the meantime, to NOT heat up the first layer, degrease etc. (at 20 degrees Celsius, we recommend 10 minutes)
- после завершения процесса применения, мы рекомендуем выйти в дневное время, чтобы убедиться, что покрытие было идеально потерто .п>
- Initial hardening of the coating takes place after 12 hours at a temperature of 20 degrees Celsius (the car may then come into contact with water), full hardening takes place within 1-2 weeks (after this period, the car can be мытый for the first time).п>
Советы:
- We recommend changing the microfiber frequently (for a car the size of an Opel Insignia we should use at least 2 microfiber)
- in case of imperfections after the coating has run in, they can be removed after 12 hours (not possible earlier! ) from the application of microfiber and a minimount of finish paste. После того, как покрытие полностью вылечено, оно может быть только удалено с полированной тканью. * Please note that after such a treatment, durability of the coating may significantly decrease!п>
- The coating can be heated at 60 degrees Celsius for 15 minutes
- Layering makes sense up to 3 layers inclusive
the composition of the set:
Nanolex Si3D 30 мл
Nanolex EX 200ml
Nanolex Pulley for applicator
nanolex Si3D applicator x3
Nanolex Microfiber 40х40 x2
Gloves x2