ERT-6447 - LIMITER Flap ACTUATOR 2.0 TDI CR ERROR P2015

REPAIR KIT LIMITER, Manifold Flap ADJUSTER + TIE/CONNECTOR for:

- VW / AUDI / SEAT / SKODA-ENGINES: 2.0 TDI CR (2008-2015)

WITH Aluminum INDUCTION MANIFOLD (OE: 03l129711e) and ADJUSTER (OE: 03L129086)

новый набор !!!

Engine проблема? The error P2015 (collector flaps error) or 008213 (collector flap position sensor error) appears is the cause of the поврежденных plastic limiter mounted on the shaft passing through the collector or the tension and springs controlled by the adjuster !!!

наш ремонтный комплект ограничивает диапазон движения клапанного двигателя на тот же диапазон, если он был новым !!!

REPAIR NOW, AT a CHEAP COST, YOUR COLLECTOR Flap ADJUSTER AND SAVE a LOT of MONEY !!!

вам не нужно заменять входные манифолды, просто используйте наши лимиты, чтобы очистить ошибки или ждать ошибок, чтобы избавиться от проблем после вождения дюжины или около километра (в некоторых случаях "CHECK ENGINE" выходит после некоторых запусков двигателя) !!!

Our limiters also often erase errors: P2004, P2006, P2008, P2009, P2015, P2016 и P2017 .

the set includes a tie rod with a bearing and a spring, which prevent backlash and thus eliminate the above-mentioned errors.

Often, Oil leaks from under the bearing as the bearing breaks down and the carbon build-up leaks out. Worn rod itself causes large slack, which causes a blockage and the motor itself burns up !!! Also the spring itself, when worn, causes problems with the motor!

the Assembly method quite simple and they are mounted to the original adjusters (as shown in the pictures below).

Assembly time is approximately 30 minutes. You can also enter on youtube.com : "P2015" посмотреть, как собрать.

APPLICATION:

VW / AUDI / SEAT / SKODA - ENGINES: 2.0 TDI CR (2008-2015)

AUDI

ALUMINUM COLLECTOR:

METHOD OF MOUNTING THE ARRESTERS:

BAND / BEARING / SPRING:

THE SET INCLUDES: