Sensor for adjusting xenon lights or suspension. Installed on a variety of Japanese vehicles.
Depending on the model, the sensor is located on the chassis and is connected to the suspension via a lever. Depending on the deflection of the vehicle, IT regulates the height of the lights or the chassis.
соль и вода будут корродировать датчики по времени. Then the "AFS" or "headlamp alignment" warning lamp indicates that headlamp or suspension alignment is not working.
The fixture usually remains intact and can be reused, making sensor replacement an inexpensive alternative to the original part.
Buying used sensors usually not profitable as experience shows that they fail after a short time due to a age.
Connecting the sensor is easy-plug in, screw on and it's ready. In some cases, a fault clearing is needed, which most workshops will To.
the sensor is a high-quality replacement.
If Your vehicle is not listed but your sensor looks the same, please send us an inquiry.
the sensor fits among others:
Lexus IS200 / 300, 1999-2005
Lexus RX400h, RX330, RX 350, 2005-2008
Lexus LS430, 2000-2006
Lexus SC430, 2001-2010
Toyota Prius, 2003-2009
Toyota Avensis T25, 2003-2008
Toyota Land Cruiser 100, 1998-2007
Honda Accord, 2003-2008
Honda CR-V II, 2001-2008
Mazda 3, 2003-2009
Mazda 5, 2005-2010
Mazda 6, 2002-2007
Mazda MX-5, 2005-2015
Mazda RX8, 2004-2008
Original Sensor numbers:
Toyota, Lexus part numbers:
89405-20020, 89405-48020, 89405-60012,
89406-24050, 89406-48020, 89406-53010, 89406-60012, 89406-60022,
89407-20020, 89407-33010, 89407-48010, 89407-48020, 89407-48030, 89407-60010, 89407-60011, 89407-60021, 89407-60022
89408-24060, 89408-30090, 89408-30110, 89408-47010, 89408-48010, 89408-48020, 89408-50060, 89408-60011,
Mazda Part Numbers:
FE03-51-21YD, FE03-51-22yc, BP4K5122YA
Honda Part Numbers:
33146-SEA-G01, 33136-SEA-G01, 33136-S9A-003, 33146-S9A-003, 33146-SED-G01
Installation Note: Before installing, remove the plug from the old sensor and connect The new sensor as a test.
Do Not over tighten the sensor axis when tightening The nut!
a layer of grease on the axle and a little Contact spray in The plug won't hurt.
Before buying, make sure that your Sensor model is specified in the description, if you not find it, ask a question.
Before buying your Old sensor, check if the paths on the board are printed as in the photo, if they are the other way, you will find them on another auction !!!
We not accept returns or replace sensors if the sensor is wrongly purchased.
All sensors are checked for function being dispatched. Вы получаете рабочий датчик.Electronics are not "RETURNED"
Состояние | Новый |
---|