Стан | Новий |
---|
Стан | Новий |
---|
The perfect solution for people who care about the aesthetics of their car . Резиновая полоса будет ниже машины. It will emphasize the appearance of your car and give it a more Sport character . It will make your car stand out in everyday traffic and attract attention . В дополнение, он будет защищать чувствительные элементы против сплинтеров под колесами и защищать бампер, когда он попытается подняться над снаряженной зоной, которая слишком высока.
< / div >✅ легко собрать. For self-assembly. Это достаточно, чтобы очистить защитную пленку и придерживаться элемента
✅ Strong and durable.Made of the highest quality, wear-resistant rubber
✅ Tape-mounted . постоянно прилипает к любому элементу без аддитивного клея
✅ It will малый the appearance of your car, give it a спортивной character and lower it visually
✅ It protects the bumper on uneven terrain and when driving over a high curb
LEN length: 2.5 meters
WID Width:4.5 см
✅ color: carbon
Materiał материал:высокое качество резины
✅ Flexible and adapts to the shape of the element
1 x лента 2.5 meters, color carbon
1 x ткань, чтобы обрезать поверхность
8 x optional mounting screws
Attention! Это рекомендовано, чтобы ремень был установлен в благоприятных погодных условиях.
Remember не прикасаться к поверхности с помощью клея. This affects the grip.
1. тщательно очистить и разложить края и место, чтобы приклеить ленту.
2. Heat the entire roll of tape, E.G. dryer until the rubber strip softens. (heating the glue will make the connection much more durable. Скиппинг этот шаг будет заметно пропитан клеем.)
4. Медленно оторвав ленту от клея и наклеив ее на область, чтобы быть убранной. After sticking the tape , Press IT firmly with your fingers.
5. Cut off excess tape .
6. Reheat the tape, e.g. dryer and press the strip against the selected element several times.
the tape achieves its adhesion after 24 hours!
Before this time has elapsed, avoid contacting the belt with water and driving at high speed
Note: in the case of sticking sharp поворотах, it is recommended to cut out the "teeth" as in the third picture