TRAKRITE BEAM
Designed for use with Gunson inclination gauges 77099 and 77066, with the wheels on and the vehicle standing on the ground. <улей>
Design registered in the EU.
Стан | Новий |
---|
Designed for use with Gunson inclination gauges 77099 and 77066, with the wheels on and the vehicle standing on the ground. <улей>
Design registered in the EU.
Make sure the vehicle is on flat, level ground with the parking brake on.
Make sure the tire pressure is within the range recommended by the manufacturer.
See pictures below: adjust the two adjustable wheel RIM spacers so they touch the top and bottom edges of the rim. И только через руку.
Adjust the top bracket by loosening the 10mm set screws; adjust so that the beam fits correctly on the rim of the wheel and (especially with ultra-low profile tires) be careful that the beam does not touch the ground. Затем снова натянул 10-миллиметровые винты.
Place the TRAKRITE beam on the tire so that Booth washers rest on the rim edges and the beam is perpendicular to the floor.
Attach The TRAKRITE inclination gauge centrally to the beam and take measurements as described in their instructions.
если колесная арка слишком низкая для Луча, чтобы повесить с шины, он все еще может быть использован, чтобы снять верхний кронштейн и держать его на месте с вашей рукой. Important Notes
• Make sure the vehicle is on flat, level ground with the parking brake on.
• проверьте давление шин и установите его на характеристики производителя.
• Check wheels and tires for damage.
• Check that wheel joints and bearings are Specification and not worn or loose. * Lock the steering wheel with the wheels straight ahead.
• Read and understand the comprehensive instructions included with our products.
Producer: Gunson - Great Britain
No. каталог: 77137
Recommended for use with the TRAKRITE GAUGE-available in our offer:
https://allegro.pl/oferta/magnetyczny-miernik-pochylenia-kola-trakrite-10711062600