JRspec Nissan 180SX CA18DET forged connecting rods
Connecting rods
a set of forged connecting rods by JRspec made in H-beam technology for Nissan 180SX S13 cars with ca16de, CA18DET engine.
They are made of the highest quality ANSI4340 (EN24) forged steel, strength exceeding 200KM на цилиндр.
Vacuum degassed before processing.
All forgings were X-rayed before processing.
Heat treated (normalized).
Surface blasted (stress-relieved) after processing.
Edges aligned.
each hole was honed twice (before and after the foot was fitted), which guarantees its perfect circle (tolerance 0.01 mm). In addition, the connecting rods have been angled (they are perfectly straight vertically), 0.01 мм - many brand manufacturers have discrepancies exceeding even 0.1 мм, which results in faster wear of the bushings!
Each single set of connecting rod + foot has its individual number. Sets are packed by weight (+/- 1g) and balanced end to END. Головы были усилены, с высокими бронзовыми кустами на месте поршневого Штыря.
Connecting rods have been tested on over 1,500 horsepower Calibra цунами.
длина: 133 мм
Pin: 20 мм
Болты: 3/8 "