Tuning driver / Speed controller for brushless motors / BLDC. Просто как наши другие контроллеры настройки, он может легко обрабатывать двигатели до 500W более мощный. Intended, среди других, for BM1418 engines available in our Allegro. Работает с обоими двигателями и без датчиков Холла.
Programming and connecting the controller - the controller is connected according to the following sequence:
- Controller power supply - два толстых красных (плюс) и черных (минус) провода подключены к батарее в соответствии с их цветами (хотя контроллер имеет свою собственную защиту, мы предлагаем установить макси-предохранитель между батареей и контроллером).Ли>
- Engine - 3 thick Engine Power cables (green, blue, yellow) для их цветовых уравнений двигателя
- Hall sensors - connect the 6 foam cube in the controller (checking if the colors of the cables match) to the 6-trunk engine cube. Пропустить этот шаг, если у мотора нет выхода датчика Холла.Ли>
- Switching on the controller - The orange wire described as "Electric door lock " is connected with the Plus powering the controller. Выход между батареей плюс и этим проводом может быть подключен к зажиганию / переключателю.Ли>
- Programming - (IMPORTANT - at this point the lever / pedal cannot be connected to the controller) after turning on the controller, turn the engine manually in the direction you are interested in, then connect the 2 white wires marked with "Intelligent recognition" together, the engine will start working for 5 -7 seconds during which the controller detects its characteristics and rotation. Когда двигатель останавливается, он отключает белые провода-в этой точке, контроллер почти не работает с двигателем, мы можем подключить рычаг / педаль и т. д.Ли>
the controller works with any type of battery supply.