spacing of mounting holes: adjustable (оптимальный диапазон от 8 см до 40 см)
20 мм deviation: optimal deviation from assembly
the set includes: 2 стойки (right and left), stainless steel mounting screws (4 M8 screws, 6 cm long), screws for adjustable rack parts with self-tapping nuts (all screws and nuts are made of stainless steel)
Advantages of the frames we offer:
<улей>
толщина: 10 мм (обеспечивает the stability of panniers)
full bar: instead of pipes, a full bar was used, which significantly increases the strength of the стойки, preventing their deformation
full проникновение welds: разрушения strength (welds not only around but on the entire joint surface)
ss304 болты из нержавеющей стали: высокая твердость по сравнению со стандартными стальными болтами
adjustment screws with self-tapping nuts: prevent the Rack components from loosening
Dedicated to: chopper, cruiser, naked, street bikes (some examples of motorcycle models are in the "Application" section below)
Deviation:
<улей>
20 мм tilting: optimal tilt for the correct positioning of panniers or panniers
the deflection профили starts at the root: the стойки therefore support the panniers with the largest possible surface area
Full проникновение welds:
Welds on the entire joint surface (not only around) ensure higher resistance to stresses.
Dimensions and adjustment range:
<улей>
The optimal dimensions and shape of the стойки provide reliable support for panniers or шины.
a wide range of adjustments and two movable parts allow for optimal positioning of the racks.
Толщина:
10 мм thick frames ensure a stable and safe mounting of panniers.
Bolts and nuts for adjusting the track:
<улей>
Self-tapping nuts были использованы для предотвращения регулируемой части рамок от unscrewing.
Viber
Telegram
