RTX РЕВЕРСИВНЫЕ ДАТЧИКИ ПАРКОВКИ СПЕРЕДИ И СЗАДИ

If you are looking for the cheapest Parking sensors, unfortunately not with us ... Но если вы ищете проверенный продукт, который будет служить вам на протяжении многих лет после установки, вы пришли на правильное место!

наши датчики были установлены на протяжении нескольких лет авторизованными дилерами ведущих автомобильных брендов и many dealer workshops, enjoying a very good opinion of customers. a set of parking sensors by RTX, модель PA2-85-8

Фирменные parking sensor kit with 8 new generation sensors and a loud signaling device designed for installation at the front and rear of the vehicle

• loud siren with adjustable Sound strength
• automatic activation of the sensors at the front when the brake is pressed
• большое измерение расстояния range - до 1.8 m
• Display resolution of the distance every 10cm
• sensitive detection of even thin posts and fencing mesh
• 5 different frequencies of sound signaling
• modern sensors with oblique transducers
• no need for angle washers
• sensors havedetachable wires for easy installation
• датчик диаметра 22.5 мм

• Distance indications are given by means of short sounds of increasing frequency as you approach the obstacle
• The volume of the audible signaling, чтобы удобно can be reduced or disabled by means of a switch located on the siren housing

• частота сигнала увеличивается с подходом к obstacle
• the Siren generates5 различных частот звуков, которые позволяют вам легко судить, как далеко вы можете вернуться
• at a distance of less than 30 см, a continuous sound signals the need to stop the vehicle absolutely

The sensors have a slim flange, thanks to which they look nice in the bumper, and the rubber tabs on the side of the body expand when pressed into the bumper, thanks to which the sensors hold крепко и надолго.

Inclination of the источника by 12 degrees upwards in relation to the sensor mounting plane perfectly replaces the angle silicone washers used in older, flat sensors.

if necessary, the angle of the emitted ultrasound beam can be properly adjusted by rotating the sensor.

This обеспечивает universal use both in vehicles with a high bumper and in those where the bumper is low.

The sensors have detachable cables.

возможность отсоединения кабеля облегчает монтаж , а в случае повреждения датчика его замена не требует демонтажа всей проводки.

The connection point is sealed with aсиликоновое уплотнительное кольцо, and the entire screw connection is a moisture-resistant, solid solution.

the set includes a hole saw with a diameter matching the dimensions of the sensors.

You can easily make aesthetic holes in just a few minutes

Kit Contents:

The set is intended for vehicles with a 12V installation