POWERFUL WELDER FOR PLASTIC WEP 8858-PRODUCT SHOWN IN the PICTURE
Support for the hotair stock
шнур питания
улей>
Complete set of nozzles.
round with a diameter of 7 mm
round with a diameter of 9 мм
square by 12x12 мм
The сварщик состояние живых характеризуется is by:
<улей>
Digitally controlled Air discharge regulation.Ли>
контроль температуры от 100 ° C до 480 ° C
светодиодный дисплей
Fast achievement of the desired temperature and high temperature stability
Fan driven by a brushless motor (high durability and надежность, quiet operation, low vibration)
The WEP 8858 пайки iron is a lightweight and portable device
максимальная мощность: 650W
температурный диапазон: 100-480 ° C
долгая жизнь вентилятора: 3000H
Automatic mode On / Off after putting it on The stand
улей>
фляжка горячего воздуха имеет эргономичную, нескользящую форму.Ли>
The flask has cooling holes that ensure good cooling and prevent contamination by dust from the environment.Ли>
The station takes 10 seconds to reach the temperature of 300 ° C
Stand for a hot air flask.
когда вы используете первый раз, please place the flask of hot air on the holder. После установки температуры, поднимите фляжку. Есть микро-контакт в сокете.
акции других производителей повреждены, когда они подвергаются воздействию высоких температур.Ли>
the stock in WEP 8858 is resistant to high temperature in the short term
Together with the station, you receive a set of nozzles, so you can start working with the device immediately.
<улей>
Round nozzle with a diameter of 7 mm
Round nozzle with a diameter of 9 мм
площадь 12x12 мм
Our nozzle is on the right side of the photo.
please pay attention to the air outlet gap for regulation with minimum Air supply! What the competition does not.
The welding machine comes with an electronic plastic welding guide. это знакомит вас с проблемами сварки пластика в легком пути и делает его легче начать работу с устройством. после покупки, пожалуйста, свяжитесь с нами по электронной почте, чтобы отправить вам руководство. Thank you.
the photo shows the construction of the heating element
Heater with a thick wire, wound on the frame-thanks to this, it is not possible to accidentally short-circuit The wire by a gentle tap