Комплект для ремонта краски FIAT 647

(10-0120)

the kit includes:

All parts of the set come from the reputable manufacturer of Motip varnishes. Набор разрешений на полный ремонт поврежденного кузова в соответствии с инструкциями ниже. Набор включает в себя лучшие и доказанные продукты, которые используются каждый день тысячами людей, любителями и профессионалами на поле варнишинга.

Remember: The photo above is иллюстративных only, and the color shown on them may отличаются slightly from the actual color. Экраны компьютеров и телефонов могут различить оттенки.

Product description:

the set includes products that are most often chosen by our clients and they are:

все вариации характеризуются очень хорошим прикрытием, коротким временем сушки и сопротивлением царапинам и непогашенным погодным условиям.

the set size is ideal for repairing Local paintwork damage.

NOTE: Store in a place not exposed to sunlight and away from other heat sources

Repair of поврежденных paint coating

Step 1

Remove rust, loose лак горячей сушки residues. Sand the surface with fine sandpaper

The surface prepared in this way should be clean, dry and free of grease

Step 2 - Use the putty from the kit

In the case of a larger cavity, apply the putty.

After the putty has hardened, Sand off the excess until a smooth transition between the varnish and the repaired item is obtained.

Step 3 - Using a primer лак горячей сушки

If the cavity is deep or if a putty is applied, a primer should be used.

Before применение the primer, secure the adjacent elements with окраски tape and paper.

Apply the undercoat in several thin layers.

Step 4 - Use a base coat

применить a spray Base coat in several thin layers on the prepared surface.

Make sure to keep an appropriate, minimum distance 20cm between the can and the painted элемент

Step 5 - Use of clearcoat and spotblender

in the case of metallic paint :the painted surface should be covered with a colorless varnish after drying.

if there is a difference between the old and the new version of the varnish, use the Spot blender varnish - varnish that levels The transitions.