WELDER PLASTIC WEP 8858 + NOZZLES + NOZZLE BUT + nozzle IRON + LONG CABLE 1m
! BUT nozzle for Professional Plastic Welders-facilitates The Binder feeding process-it is recommended! !
! The iron nozzle facilitates The modeling of the weld, smoothing The binder, fusing The reinforcing mesh!
FAN-BLOW SOURCE
Retail offer!
The BEST PLASTIC WELDER WEP 8858-I PRODUCT SHOWN IN the PICTURE-OTHER PRODUCERS IMITATE US
X5 NOZZLES with reduction nozzle, BUT nozzle, Iron nozzle
SET142
SET CONTAINS:
WEP 8858-я welder
Support for the hotair stock
улей>
a set of 6 nozzles in total
round with a diameter of 7 mm
round with a diameter of 9 mm
площадь 12x12 мм
+ 1 reduction nozzle for the but nozzle
+ 1 but nozzle!
+1 железная насадка
улей>
* no binder included
Technical specifications:
Digitally controlled Air discharge regulation.Ли>
Air flow regulation up - 22 л / мин макс.
контроль температуры от 100 ° C до 480 ° C
Power энергопотреблением: 650 ВТ
светодиодный дисплей
Air flow source:fan
Air flow: up составляет 120 л / мин
Blowing type: Soft start brushless fan
Длина кабеля: 1 m
Size: 305x60x60 [length, height width]
Strong heater made of thick wire mounted on a frame (greater strength and durability of the heating element)
BUT nozzle in the photo on the right
the photos below show an example of how to set up and use the BUT nozzle-nozzle included!
The But nozzle is placed on the round nozzle with a diameter of 9 мм, which is included in the set
Welding with the but nozzle-an additional hole in the nozzle is provided for plastic insertion
Welding without a but nozzle
The iron nozzle is pictured on the right
Used for
Оперение reinforcing mesh,
smoothing The weld,
улей>
This saves you time on the final processing of the weld.
Nozzle Iron dimensions
Fits welders with an outlet diameter of 22 мм
Working surface :triangle with sides 25x20x25 мм
сварочная машина поставляется с электронным пластиковым сварочным гидом. это знакомит вас с проблемами сварки пластика в легком пути и делает его легче начать работу с устройством. после покупки, пожалуйста, свяжитесь с нами по электронной почте, чтобы отправить вам руководство. Thank you.
the photo shows the construction of the heating element
Heater with a thick wire, wound on the frame-thanks to this, it is not possible to accidentally short-circuit The wire by a gentle tap
the photo shows the construction of a heating element covered with mica
Calculation of the profitability of welding
Typically, the price of the service is calculated based on the type of crack:
difficult fracture - до 2/10 мм
улей>
средняя трещина составляет 1.5 PLN / 10 мм
улей>
- до 1/10 мм
улей>
other cases of repair of plastic elements according to individual arrangements
улей>
for example: in case of a break of a moderately difficult bumper with a length of 70 cm, the purchase is returned after the repair of 2-3 bumpers.
Viber
Telegram
