EPLHM31 - Светодиодные лампы H1 флип чип 12 / 24V Canbus мотоцикл

Thanks to the use of the most modern technology with the use of FLIP CHIP нем, it was possible to design a small bulb (the small core of the bulb allows installation in very small lenses ). Высокая световая эффективность флип-чип диоды вместе с высокой текущей интенсивностью2.5 amps при напряжении14.4 V позволила нам преодолеть5000lm от одной лампы. Small construction, narrow bulb shaft, lack of external elements (module / driver) allow for much easier installation in most motorcycles than in the case of competitor bulbs. You can remove the fastening from the bulb, which often makes installation very easy.

The bulb has the so-called "cut-off", thanks to which they do not blind drivers from the opposite direction, which is the case with other LED bulbs (pay attention during assembly to install the bulb under the correct angle).

Bulb characteristics:

FLIP CHIP LED - is an innovative LED chip assembly technology that eliminates many disadvantages typical of technologies commonly used on the market:

Conventional LED shows high thermal resistance due to the low thermal conductivity of the sapphire substrate.

Significant amounts of heat are emitted from the active layer through the diode front, the инкапсуляции материал and then dispersed in the air.

The diode made in the Flip Chip technology is designed on a термально conductive substrate with metal connections,

The problem with the extraction of light from the chip is the metal contacts that obscure part of the light-emitting surface. In classic LEDs, losses associated with the classic method of assembly reach 20%. Эта проблема не в случае с откидными чипами, которые не используют провода для подключения светодиодных чипов.

Benefits:

Нем placed at the same height as the light source in an ordinary halogen bulb, thanks to which we obtained the so-called "cut-off", thanks to which we do not blind anyone while driving on our bulbs.

Included:

Note: Not always the part sold in the auction fits the vehicle, because the periods given above are the production time of a given model, not the time of using the part. Эти периоды не всегда совпадали, и это было не для двух или более типов частей, чтобы быть использованными в одной модели. Please compare the photo from the offer and the technical description contained in the item description with the part installed in your car. - Не надо, пожалуйста, проверять правила применения.